Guy's Magnets 18 mm x 3 mm ferrite disk

Manufacturing tolerances: Diameter +/-0.36mm, Thickness +/-0.1mm Magnetised through the thickness so that one flat face is north and the other is south

Guy's Magnets 16 mm x 3 mm ferrite disk

Manufacturing tolerances: Diameter +/-0.32mm, Thickness +/-0.1mm Magnetised through the thickness so that one flat face is north and the other is south

Guy's Magnets 11.4 mm x 12 mm C5 ceramic ferrite rod / disk

These magnets are all new, directly from the manufacturer, however, they have been cut from a larger block and it is not unusual for the edges to have chips and nibbles or for there to be patches of discolouration. This does not affect the either the power or performance of the magnets Magnetised axially through the thickness so that one 100x25mm face is north and the other is south +/-0.1mm manufacturers cutting tolerance

Guy's Magnets C8 20mm x 3mm ferrite disk magnet - craft fridge DIY MRO - PACK OF 50

Technical Specifications Diameter: 20 mm (0.78") Thickness: 3 mm (0.11")Manufacturing tolerances: Diameter +/-0.4mm, Thickness +/-0.1mm Axially Magnetised through the thickness so that one flat face is north, the other is south Weight: 4.6g Grade: C8 (In a size for size comparison, a C8 grade magnet will have approximately 2-3 times more pull than the same size C1 craft magnet.) Coating: None Maximum Temp: 250°C / 482°F Theoretical Maximum Pull: 0.5lb / 8oz / 229g Calculated Max Vertical Hold-guidance only: 0.1lb / 1.6oz / 45g WARNING: We would not recommend this magnet be used by children under 3, and not by children under 5 without supervision - choking hazard and soft tissue pinching hazard.

Guys Magnets 20 mm x 3 mm C8 ferrite disk

Manufacturing tolerances: Diameter +/-0.4mm, Thickness +/-0.1mm Magnetised through the thickness so that one flat face is north and the other is south

Guy's Magnets 14 mm x 3 mm C8 Ferrite disk

Manufacturing tolerances: Diameter +/-0.28mm, Thickness +/-0.1mm Magnetised through the thickness so that one flat face is north and the other is south

Guy's Magnets 12 mm x 3 mm ferrite disk

Manufacturing tolerances: Diameter +/-0.24mm, Thickness +/-0.1mm Magnetised through the thickness so that one flat face is north and the other is south