Guy's Magnets 20 mm x 6.4 mm x 5 mm countersunk neodymium ring

These are ideal for a range of holding applications Axially Magnetised through the thickness so that face with the countersink on is magnetised north, while the flat face is magnetised south +/-0.1mm manufacturing tolerances on any dimension Countersunk for an M6 screw

Guy's Magnets 120 mm x 20 mm x 15 mm C8 multipolar ceramic ferrite block

+/-0.25mm manufacturing tolerance on any dimension MULTIPOLAR: Each 120x20mm face is magnetised into four alternating poles.  The opposite poles appear on the other face.

Guy's Magnets 135mm x 28mm Ferrite Pot Magnet with 57mm steel boss & M14 eyelet bolt

Magnet inside steel cup measures 121mm diameter x 22mm thick +/-0.2mm manufacturers tolerance on any dimension The height of the boss is 30mm with an internal M14 thread The M14 steel eyelet, when screwed into place, is 55mm in height giving a total height of the eyelet and boss of 85mm The eyelet has a 29mm hole for attaching rope. Magnetised axially through the thickness The pull of these magnets was tested in a test rig and will be at LEAST the figure shown The vertical hold is 1/5th of the pull and is, therefore, only for guidance  

Guy's Magnets 17.5 mm x 5 mm S2:17 shallow pot

These are specifically designed for press fitting into application and, as such, have no method of anchoring. +/-0.2mm manufacturing tolerances on the steel shell. Diameter of magnet: 14 mm +/-0.2mm Thickness of magnet: 4mm +/-0.5mm THIS IS NOT A TOY, choking hazard. Pull and hold calculations are approximate only are only for guidance.

Guy's Magnets Small Magnet Clip strong office / fridge / whiteboard magnet

Maximum length 34mm Width 31.7mm but rising to 33mm at the hinge Maximum depth 21.5mm Holds up to 16 sheets of A4 on our office fridge WARNING: may scratch shiny surfaces, if necessary, use a piece of paper between your whiteboard/fridge and the clip and then use the clip to hold other papers.

Guy's Magnets 50mm X 10.5mm Ferrite pot magnet with 8.5mm hole

Magnet inside steel cup measures 45mm outer diameter x 22mm inner diameter x 8mm thick +/-0.2mm manufacturers tolerance on any dimension Magnetised axially through the thickness The pull of these magnets was tested in a test rig and will be at LEAST the figure shown The vertical hold is 1/5th of the pull and is, therefore, only for guidance

Guy's Magnets Vehicle Mag Pad 1

Maximum Holding force 9kg Tested to 70mph M6 thread and nylock nut 16mm stud length Foam is just present as a place holder and is not part of the product

Guy's Magnets 25 mm Ferrite Banner Hook

Ferrite magnet Steel cup with thread Threaded steel hook inserted White powder coated Height of hook to apex 36.76mm

Guy's Magnets 32 mm Ferrite Banner Hook

Ferrite magnet Steel cup with thread Threaded steel hook inserted White powder coated Height of hook to apex 35.5mm

Guy's Magnets 1/4" neodymium cube

+/-0.1mm manufacturers tolerance on any dimension Magnetised through the thickness

Guy's Magnets Name Badge Fastener

DOES NOT INCLUDE NAME BADGE Name Badge not included - this is the fastener ONLY. WARNING: NOT FOR USE BY PEOPLE WITH PACEMAKERS Length: 45.5 mm (0.39") Width: 13 mm (0.51") Thickness: 1.35mm (0.05")including steel plate and foam pad Weight: 10.6 g Grade: N35 Coating: Ni-Cu-Ni (Nickel-Copper-Nickel) Maximum Temperature: 50°C / 122°F